Skip to main content

In short

Click the import button, like “Import 120 products”. A window called Confirm import shows the count and the total cost. Click Confirm. Your products are now in Purchases and Capital Recovery. Every product comes in, with or without a cost. A product with no cost is never shown as $0.00. Say you import one blender: 20 units at $8.00 each. The window says “Import 1 product, total cost $160.00.” When it’s done, the title says “1 product added”. The button is Enter SourceDock.

More details

The button counts products, not purchases. One product can turn into more than one purchase, like when its boxes have different prices.
The ship date is the day Amazon received the units.The purchase date is the day of your buy sheet row that priced it. With no sheet row, it’s the date in the shipment’s name, or else the day Amazon received the units. A date you set yourself stays.
The bar says “1 product · No cost yet”. The window has no dollar total, and the row says Needs a cost.When it’s done, the line says “That’s 1 purchase.” If your store has purchases that need a cost, it adds a count like “1 purchase needs a cost.” That count is your store’s whole Cost needed list on Purchases, not just this import.
The window says Importing purchases, with a bar and Cancel. It says Your import is running. Stay on this page until it finishes. while the page is still sending it.Then it says Your import is running. You can keep using SourceDock. A small minus button shows. Its tip says Minimize. The import keeps going. It also takes you out of setup to the desk.
The line adds “1 product was not added. Check it, then import again.” Check it takes you back.If some products are still waiting, it can add “1 more is waiting in Purchases › Import from Amazon.”
Your matches, and which step you were on, are saved on SourceDock’s side, not just in this browser. Finish later saves them before you leave. See Leave and come back.